rsmithsr
Registered User

simple green and industrial paper towels rub and scrub re lube when done

me too tho mine are just bob c.

sorry but poor decision. lets start with some basics bullets and cases are inert...very stable tho some targets disagree. powder is...

i paid $4600 for a 2 year old $12000 lathe (prices at the time). it was 220 3 phase...little "home" market. taken in trade by a commercial machine...

this is getting childish my indicators have marks on the dial. there are gaps between the marks. one can SEE less than .0001, but it is not a...

"mechanically" yes but no guaranty's what it will get you. ( your terminology had me confused, std TURN IN rings, are adustable for windage)

i did not see anyone say "machine to less than.0001". nor "better than a tenth" what i said was that dialing in to .0001 is possible in an...

it's an ADJUSTABLE 3 JAW CHUCK grip in the jaws, adjustment on the od

sorry but it just aint true. temp control in shop helps but temp works on all expansion..not just one direction. and its a 3 , so no pairs. ...

multiple fast foods plus an albertson's about 2-3 miles from range.

sorry but it can be done, you are mistaken. bbl chambering,'

as always, you should take that to a BENCHREST MATCH WITH THOSE GROUPS.

ACETAMINOPHEN All drugs have two names, a trade name and generic name. Example, the trade name is Tylenol and its generic name is ...

too anal in short range benchrest....nah

but i do 25 to 50 pcs at a time in most cases. i am happy with my process. at 72 i have not stopped learning, but my vision(only one eye) does...

i did not realize the great sense of humor you have.

because i am nowhere near as good as jackie on a lathe, i do not turn big lots i use my lathe as a powder source to rotate the case, and hand...

why would you want to adjust seating depth ? 1) seat to the bottom of the pocket 2) add a small crush in place about .002 not seated to the...

a six jaw adjustable chuck ??

while we ARE in the 21st century, you could move into the 20th with and adjustable 3 jaw chuck. all of my bbls are done in a adj 3 jaw...yes they...

depends on the type of three jaw see what jackie just said.

yes it will...you are moving in on each cut...while a straight plunge does not. can you back out your stop at each cut ??

the tip of the tool

sorry but if you move a tool in to the left, the tip of the tool will remove metal as will the left side. the right cutting edge touches nothing as...

'SPLAIN that to me ? how does moving a cutting tool to the LEFT at 29.5* cut on the right ? the 29.5 is a angle cut, not a straight in plunge.

this was very true when people GROUND THEIR OWN TOOLS. which was how i started. today i grind very little. most is available over the counter.

why not just an indicator ?? esp for a crown or a ppc chamber

the difference today is i have the timney and not the 200 for a jewell.