rsmithsr
Registered User

generic m14's are not great target rifles. what twist is your bbl ? the best my m14 ever did was just under .9 at 200. the method was on a bench,...

there current delivery software is a JOKE. AND THE EMPLOYEES HAVE TO ANSWER THE PHONE AND PRETEND IT IS ALL TRUE there is no excuse for it...

classic case of voicing an opinion WITH NO FACTS. go read the laws then come back. " legally licensed maker" not! here is a clue ffl not required...

take a look at BIRMINGHAM lathes, looks like the same family.

well ya have me confused(EASY TO DO) but the us mil cannot use non-usa made powders. so lot xxxxxxx milsurplus ain't vith powder. while "8208" as a...

can anyone explain this to me. a seven year old post and a reply that has nothing to do with the question ??

he has zero published history. i know who he is, but would like to see RESULTS in bench rest. big negative is his comment that he cannot guarantee...

pm sent

the good news is that since it is now a creedmore, no load development, just point in the general direction of the targets and it hit the middle...

thank you gentlemen marine tex is up next

no, but your doctor supports a lawyer and a paper mill. in case anything goes wrong, it was not his fault. and you agree. typical today. maybe go...

i shoot a tmbr clone in a 30 br for mainly club score. hopefully some comp shooters will join in

pretty close to my current process. i do not bed the bbl and nowhere near as much bedding material to start with. in one pic i think you can see...

yes take your grandkids shooting, it is entirely possible their parents will not

i do have hss, maybe i should just try that since i am so slow. i remember why...too big..cannot get close to shoulder......... the carbide tool...

a bullet and n133 ??

like all loads start low and work up. a felt pellet is weight, adds resistance, may add pressure quicker i shoot pretty much powder only

my class was for small southbend lathes.

i was taught in lathe school to use 29. jackie was taught by his dad as i recall, not in a class. i use 0 with my current setup. anyone have a fact...

i am using a solid tool holder, 0 degree and cutting away. sorry just no tool crash on a good part. yes i clean them up, they thread on...